Now with premium ER20 Collets!
This industrial quality 2400W motor produced exclusively for Wood Workers Workshop to run on 230V power offers variable speed control between 10,000 to 20,000 RPM with premium ER20 collets for increased cutter grip with reduced runout, extending cutter and bearing life. The quiet running high torque motor tackles the most demanding of timbers with ease for safe and reliable router table work. With a unique pre-wired variable speed remote control unit, isolator and NVR (No Volt Release) switch.
This fixed base router is fully compatible with American style router lift systems including INCRA and JessEm Mast-R-Lift II, therefore allowing for precise and easy adjustment of cutter height without any cutter length loss below the table. The motor shaft and auto-release ER20 collet raise above the table for easy cutter change with the supplied spanners. The soft-start variable speed control is sealed for reliability in the hard-working environment of a router table or CNC machine and is engineered to maintain constant speed under load.
This router is designed specifically for use with router lifts and CNC machines that require a 106mm (4.2") diameter router. AUKTools fixed base router is not to be used freehand.
Safety First!
- No more scrambling under the table trying to find the controls for your router, you can operate your router smoothly and safely using the on/off switch and variable speed remote control unit
- The NVR switch means that if you suffer power loss, your router will not restart until you manually switch it back on
- The emergency stop button locks on and can only be released when you physically twist to unlock it, allowing you to isolate your router whilst you change cutters
Easy to Use
- Locate your remote controller unit wherever suits you, on the wall or on the side of your router table
- Plenty of cable to play with - 1.3 metres between the router and the remote controller unit, plus 2.8 metres between the remote controller unit and the power supply
- Particularly useful to owners of the INCRA Clean Sweep box and Insert Rings as the fully enclosed router is now controllable outside the box
Includes
- AUKTools 2400W Router Motor
- Pre-wired Remote Speed Control and NVR Switch
- Offset Collet Wrenches
- ER20 1/4” Collet (1/4" and 6mm shank cutters)
- ER20 1/2” Collet (1/2" and 12mm shank cutters)
- Spare Set of Brushes
- Owner's Manual
Specification
- Voltage: 230V 50Hz
- Power Input: 2400W (3.25HP)
- Power Output: 1800W (2.4HP)
- No Load Speed: 10,000-20,000 RPM
- Soft Start Quiet Running Motor
- Current Overload Motor Protection
- Cable Length: 4.1 m
- Plug Format: Three-pin
- Weight: 4.54kg (10lbs)
