If you are already registered, please log in.
Create your account and enjoy a new shopping experience.
Create A New AccountINCRA's Gauge can be used in place of a ruler or adjustable square to quickly and accurately mark out reference lines on any workpiece. Works as a precision marking gauge, a freestanding depth-of-cut gauge, a fence alignment gauge and a centre finder.
Uses genuine INCRA racks for INCRA precision. Next to our rules, you will find the Incra Gauge to be your most indispensable layout tool in no time at all.
To set the gauge, loosen the clamping nut and move the top half of the gauge to the distance that you want to measure (as indicated by the imperial scale on the bottom half of the gauge that reads 'EDGE DISTANCE'.) Butt the lip of the bottom half against the edge of the board and make your mark along the end of the top half.
It also works as a free-standing depth of cut gauge for setting the blade or bit height on the table saw or router table. Set the top half of the gauge to the desired measurement (as indicated by the imperial scale on the bottom half of the gauge that reads 'HEIGHT'.) Tighten the clamping nut and use either end of the gauge to set the height of your cutter.
INCRA
INCRA Miter Gauge V27 is engineered to provide a high performance, yet low cost upgrade for any tool in need of a better miter gauge such as a Table Saw, Band Saw, Router Table, Disk Sander or
INCRA
INCRA Miter Gauge V120 features an incredible 120 angle stops which are laser cut into the steel protractor, with a stop available for every whole degree and two special stops at 22.5 degrees...
INCRA
The protractor plate's exclusive AngleLOCK Indexing System has a whopping 180 can't-miss angle stops in 1-degree increments with special stops located at 22.5 degrees. The HD stands for High...
INCRA
INCRA's AngleLOCK Indexing System delivers 364 lock solid angle stops in 5 degrees, 1 degrees and 0.5 degree increments over a full 180 degrees range with continuous adjustability between...
INCRA
INCRA Miter Gauge 5000 blends the incremental angle control features of the Miter 3000SE with a very special 3-Panel Sled for the ultimate miter cutting workstation for the table saw. A Renewable...
INCRA
INCRA's AngleLOCK Indexing System delivers 41 lock solid angle stops in 5-degree increments over a full 180-degree range. Combine this with the included GlideLOCK Miter Bar, Telescoping...
