If you are already registered, please log in.
Create your account and enjoy a new shopping experience.
Create A New AccountAfter-market table saw accessories have always faced the same dilemma, mitre gauge slots vary by both design and manufacturing tolerance. Woodpeckers founder, Rich Hummel, solved the problem while working on the original Woodpeckers Saw Gauge. By dropping two small polished pins in the bottom of the slot and placing a larger pin between them, the middle pin stays precisely centred regardless of the mitre slot width or any deviation from end to end. It doesn't matter what kind of saw you have, old, new, American, European or Asian if the slot is in the range 3/4" then the Woodpeckers Saw Gauge 2.0 registers precisely on the centre of the mitre slot.
Drop the pins in the mitre slot, adjust the arm on the gauge so the dial indicator just kisses the saw blade and check it at the front and back of the blade. It's that easy.
While Woodpeckers original Saw Gauge uses the same slot location method, it has a maximum reach of 165mm (6-1/2 inches). In version 2.0 version, the arm that holds the dial indicator can be extended using the supplied extensions.
The basic arm of Saw Gauge 2.0 has a little over 125mm (5 inches) of travel, just right for mitre slot to blade measurements. Add the extension and you can check your rip fence for parallel up to 508mm (20 inches) away from the mitre slot. Check at several different points along the travel of the fence and you have just confirmed that the rip fence rail is perpendicular to the mitre slot. The supplied extra-long, tight-tolerance track connectors ensure that the arm is rigid and straight.
The Woodpecker Saw Gauge 2.0 come in a moulded case for safe storage.
Woodpeckers
Woodpeckers Saw Gauge is a dial indicator and a tool that rides perfectly down the centre of the miter slot, creating the perfect saw cut by ensuring the saw blade and rip fence...
iGaging
This digital alignment tool will allow you to test your table saw alignment, fence alignment, router and drill press arbor run out, set jointer knives, saw blade and lathe run out and much more. <
iGaging
When setting up your machinery the question of either using an analogue height and depth gauges or using a digital readout to set your system up has split opinion for years. iGaging have the answer,...
Woodpeckers
Woodpeckers Hold Down Clamp is by far one of the easiest ways to clamp wood along a T-Track and has more capacity than most surface-mount toggle clamps. Better than other hold-down clamps, the...
Woodpeckers
The Woodpeckers 900mm Woodworking Rule is a superior heavy-duty rule with accurate laser engraved markings on a 30 degree bevel; it also has a standard and a centre scale, plus it sits flat...
Woodpeckers
The Woodpeckers Woodworking Rules are superior heavy-duty rules with accurate laser engraved markings on a 30 degree bevel; it also has a standard and a centre scale, plus it sits flat. Woodpeckers...
